Frequent Questions: Annual Catch Limit Monitoring
Annual Catch Limit Monitoring Information in the Southeast Region
Background
What are annual catch limits?
- An annual catch limit (ACL) is a level of catch intended to ensure overfishing does not occur.
- ACLs are set less than or equal to the overfishing limit (OFL) and acceptable biological catch (ABC). An OFL is an estimate of the catch level above which overfishing is occurring, while the ABC is the maximum level of catch allowed and accounts for scientific uncertainty in the OFL. ACLs are set higher than the annual catch target (ACT). The ACT is a level of catch set to account for management uncertainty. This tiered system (see Figure 1) is designed to prevent overfishing a stock.
- ACLs and ACTs are expressed either in pounds or numbers of fish.
- If an ACL is exceeded, accountability measures (AM) are triggered.
- An AM is a management control intended to prevent ACLs from being exceeded, and to correct or mitigate overages of the ACL if they occur. AMs can be implemented in-season or postseason. AMs may include regulatory changes such as a quota closure, a reduction in the next year’s ACL, implementation of a closed season, modifications to bag limits or trip limits, etc.
Why were annual catch limits implemented?
- The Magnuson-Stevens Reauthorization Act of 2006 established new requirements to end and prevent overfishing through the use of ACLs and AMs. Implementation of ACL/AM provisions were required in 2010 or earlier for stocks subject to overfishing, and in 2011 or earlier for all other stocks under federal management, with a few limited exceptions (e.g. annual stocks).
Who implements annual catch limits?
- Regional fishery management councils are responsible for setting ACLs through development of fishery management plans or plan amendments. Fishery management plans or plan amendments approved by a regional fishery management council are submitted to the Secretary of Commerce for review and approval, disapproval, or partial approval. If approved, acls are implemented and monitored by NOAA Fisheries.
How are annual catch limits determined?
- For stocks that are assessed the assessment specifies the OFL. Then each council’s Scientific and Statistical Committee (SSC) reviews the assessment and recommends an ABC, which is the maximum allowable catch of the stock after accounting for scientific uncertainty. The regional fishery management councils then review the ABC recommended by the SSC, and specify ACLs and/or ACTs. A council cannot exceed the ABC recommendation of their SSC but can specify an ABC below the SSC’s recommended level. The councils may choose to set the ACL and ACT equal to the ABC, or reduce the ACLs and ACTs below the ABC to account for management uncertainty.
- Some stocks are not assessed because there is not enough information (e.g. landings, growth, reproduction, index of abundance) on the stock to complete a stock assessment. For stocks that are not assessed a SSC typically review historical landings to define OFLs and ABCs. The councils review OFLs and ABCs defined by their SSCs and then establish ACLs and/or ACTs for unassessed stocks.
Commercial Annual Catch Limit Monitoring
How are commercial annual catch limits monitored for stocks without individual fishing quotas?
- Dealers electronically report commercial landing purchases weekly.
- The NOAA Fisheries’ Southeast Fisheries Science Center (SEFSC):
- reviews and checks the landings for duplicates and errors;
- expands the landings to account for late dealer reports;
- assigns landings to fishing year and fisher-reported catch area;
- calculates quota projections to compare to ACLs and ACTs;
- summarizes the landings; and
- provides the NOAA Fisheries’ Southeast Regional Office (SERO) reported and expanded commercial landings estimates every week.
- SERO uses the commercial landings monitoring summary to determine in-season closures, postseason AMs, and ACL/ACT adjustments.
- Commercial dealers are required to submit trip tickets to the Southeast Fishery Science Center (SEFSC) online, once per week, by 11:59 p.m., local time, every Tuesday. The SEFSC investigates potential errors and tallies landings reports (as described above) after landings are reported. Landings are then provided to SERO from the SEFSC by the end of each week and posted to the SERO ACL monitoring Web page.
How are commercial annual catch limits monitored for Gulf of Mexico red snapper and grouper-tilefish stocks with individual fishing quotas?
Landings of species managed by Gulf of Mexico IFQ programs are electronically reported to SERO by IFQ dealers. Landings are updated in real-time on the Catch Shares Website. Figure 3 provides a flow chart of the commercial landings ACL monitoring procedure for stocks with individual fishing quotas.
- Commercial landings provided on the SERO Website are used for ACL monitoring, and may differ from landings provided on other NOAA Websites, such as the Office of Science and Technology (OST) Website. Commercial landings used by SERO may differ for the following reasons:
- The SERO site assigns landings to fishing year because some stocks have a fishing year that is different than a calendar year. For example, the Gulf of Mexico king mackerel fishing year is July 1-June 30, instead of January 1-December 31.
- OST’s commercial statistics Website summarizes all landings in whole weight. The ACLs for some stocks are monitored in gutted weight; therefore, SERO landings are provided in gutted weight for these stocks.
- The SERO site assigns landings to regional management council jurisdictions while the OST site assigns landings by water body (Gulf of Mexico, which includes the Florida Keys; South Atlantic). For example, South Atlantic black sea bass landings north of Cape Hatteras, North Carolina, are reassigned to the Mid-Atlantic Fishery Management Council. Atlantic dolphin, wahoo, king mackerel, and Spanish mackerel landings include the entire East Coast of the United States. Additionally, confidential data may be omitted on the OST site.
Recreational Annual Catch Limit Monitoring
How is recreational annual catch limit monitoring conducted?
Recreational landings include data from the Marine Recreational Information Program (MRIP), Southeast Headboat Survey (Headboat), Louisiana Department of Wildlife and Fisheries creel survey (LA Creel), and the Texas Parks and Wildlife Department creel survey (TPWD). Once landings are received by the SEFSC, they are checked for errors, any necessary weight estimates are generated, and the landings are combined into an ACL dataset for monitoring landings. Landings are then sent to SERO, where they are assigned to region and fishing year and used to prepare landings summaries, in-season quota projections and closure notices, and post-season AMs for season length adjustments. Figure 4 provides a flow chart of the recreational landings monitoring procedure for ACL monitoring.
- MRFSS was phased out and replaced by MRIP in a series of steps. MRIP provides a more scientifically sound methodology for estimating catch that removes the potential for biases when gathering data, resulting in more accurate catch estimates. In 2013, a new Access Point Angler Intercept Survey was implemented to remove sources of potential bias from the sampling process. In 2018, a new household Fishing Effort Survey (FES) was implemented to improve efficiency and minimize the risk of error in private boat and shore effort estimates. The new household FES is the effort component of the MRIP survey, and the effort survey switched from a phone to a mail survey. The phone survey is called the Coastal Household Telephone Survey (CHTS). This change in the effort survey from phone to mail was done because it was determined a mail survey was superior to the random-digit dialing of residential households used by the phone survey. FES samples households from a national database of mailing addresses, which is supplemented with information from state-based recreational fishing license and registration programs.
Are all landings monitored using Marine Recreational Information Program data?
- No. The transition from MRFSS to MRIP requires the fishery management councils to revise all ACLs because the landings estimates from MRIP are different than the estimates from MRFSS. Some ACLs have already been revised while others will be changed in future amendments. For those stocks whose ACLs have not been updated to MRIP, a back-conversion is applied to the new MRIP data using a ratio of historical MRFSS and MRIP landings to convert the current MRIP landings to MRFSS landings. The details of this conversion can be found in the MRFSS/MRIP Calibration Report (2012).
Are all landings monitored using Marine Recreational Information Program Fishing Effort Survey data?
- No. In 2018 the effort component of MRIP changed from a phone (CHTS) to a mail survey (FES). This change to the effort survey results in different MRIP landings. Therefore, the ACLs will need to be converted from MRIP CHTS to MRIP FES landings. The transition from MRIP CHTS to MRIP FES requires the fishery management councils to revise all ACLs. Some ACLs have already been revised while others will be changed in future amendments. For those stocks whose ACLs have not been updated to MRIP FES, a back-conversion is applied to the new MRIP data developed from a benchmark period when both MRIP CHTS and MRIP FES were run at the same time.
Why do landings in weight differ between Marine Recreational Information Program and the Southeast Fisheries Science Center’s annual catch limit dataset?
- Occasionally, MRIP will generate numbers of fish landed without corresponding weight estimates or use weight estimates based on only a few fish samples. The SEFSC backfills missing weight estimates and pools additional samples when sample sizes are low, which results in differences in weights between MRIP and the SEFSC’s ACL dataset. Details of the SEFSC’s weight estimation method are provided in SEDAR 32-DW-02 which can be found at http://sedarweb.org/docs/wpapers/SEDAR32_DW02_Matter%26Rios_2.5.2013_FINAL.pdf
What recreational landings are used to monitor annual catch limits?
- Gulf of Mexico: Landings used to monitor ACLs include data from MRIP (or MRIP back converted to MRFSS if the Gulf of Mexico Fishery Management Council has not yet made adjustments to the MRFSS-based ACL), Headboat, LA Creel, and the TPWD.
- South Atlantic: Landings include MRIP (or MRIP back converted to MRFSS if the South Atlantic Fishery Management Council has not yet made adjustments to the MRFSS-based ACL) and Headboat. Additionally, special surveys are conducted by some South Atlantic states to monitor red snapper catches.
When are recreational landings available from each data source?
- The different datasets that comprise the recreational landings are available at different times of the year. MRIP landings are generated by two-month wave, and are typically provided within 45 days after a wave ends (e.g., May-June landings are usually provided by August 15th). Headboat landings for species with in-season closures are typically available within 1 month of landing, and an annual summary of Headboat landings for all stocks is available by March of the following year. TPWD provides landings twice a year for low-use (November 21 to May 14) and high-use (May 15 to November 20) waves. TPWD low-use wave landings are available by fall (~October) and TPWD high-use wave landings are available in spring (~March). LA Creel landings are available approximately two weeks after landing.
Why might recreational landings on the Southeast Regional Office website differ from landings on NOAA’s Office of Science and Technology website?
- Recreational landings provided on SERO’s Website are used for ACL monitoring, and differ from landings provided on the OST Website. Recreational landings used by SERO may differ for the following reasons:
1. SERO’s assigns landings to regional management council jurisdictions while the OST Website assigns landings by water body (Gulf of Mexico, which includes the Florida Keys; South Atlantic). For example, SERO reassigns recreational landings for black grouper, gag, greater amberjack, mutton snapper, yellowtail snapper, Nassau grouper, goliath grouper, snowy grouper, and blueline tilefish in the Florida Keys (Monroe County) from the Gulf of Mexico region to the South Atlantic. Also, South Atlantic black sea bass landings north of Cape Hatteras, North Carolina, are reassigned to the Mid-Atlantic Fishery Management Council.
2. SERO landings are summarized by fishing year. The fishing year for most stocks begins January 1 and ends December 31, but fishing years for some stocks do not follow a calendar year. For example, the recreational fishing year for South Atlantic greater amberjack begins May 1st and ends April 30 of the following year.
3. SERO recreational landings include Headboat, LA Creel, and TPWD landings in addition to MRIP FES and CHTS landings. The OST Website only provides MRIP FES landings.
4. ACLs in the southeast region are in MRFSS, MRIP, and MRIP mail survey units. Landings on the SERO Web site report recreational landings back-converted from MRIP to MRFSS units if the ACL for a stock or stock complex is still defined based on MRFSS landings data. SERO provides landings based on MRIP if the ACL has been defined using MRIP landings data. SERO also provides landings based on MRIP mail survey if the ACL has been defined using MRIP mail survey landings data. The OST Website only provides MRIP mail survey landings.
5. Occasionally there are survey results which have estimates of landings in numbers but no information on length and weight. OST and SERO landings in weight are generated from different weight estimation procedures. OST looks for similar samples (same species caught in as close to the same area and time period as possible) where weight were available, and randomly selects them to fill in the missing values. They will select up to five weight samples from similar samples to fill in the missing information. If there are more than five fish missing both length and weight information from a trip then the length and weight information selected from the five similar samples will be applied to the remaining catch where length and weight information was not available. The SEFSC generates weight estimates for the SERO landings using methods which require a minimum of 30 samples from similar samples where weight was available to determine an average weight. Details of the MRIP weight estimation method are provided in SEDAR 32-DW-02.
6. The OST Website summarizes landings in numbers and whole weight. However, some of the ACLs are defined in gutted weight. If the ACL is defined in gutted weight then gutted weight landings are presented on the SERO Website.